RAD Data comm Modular Access Device with Integrated Router Manuel D’Utilisation

FCD-IPM Installation and Operation Manual 

Chapter 5  Setup Menu 

 

Routing/Bridging Menu 

5-23 

 

 IPX ROUTING SETTINGS (Device name - FCD-IPM) 

 -------------------- 

 

 1. LAN IPX net for frame type 802.3        - 00000000 

 2. LAN IPX net for frame type Ethernet II  - 00000000 

 3. LAN IPX net for frame type 802.2        - 00000000 

 4. LAN IPX net for frame type SNAP         - 00000000 

 5. Dial-in IPX net                         - D2162747 

 6. Autolearn of zero LAN IPX nets          - [Enable] 

 7. RIP/SAP mode 

 

 ESC - Return to previous menu 

 Choose one of the above: 

Select this parameter to specify parameters required for operating FCD-IPM as an 
IPX router. 

LAN IPX Net for 

Frame Type 

 

Each of these parameters specifies the IPX Nets associated with a 

particular frame type. If FCD-IPM is in Autolearn enable mode, then 

non-zero values point to learned Net. FCD-IPM supplies default values 
for these frame types that can be configured on PC's operating on LANs 

without other IPX routing. 

Dial-in IPX Net 

 

Specifies the IPX Net definition for a WAN interface 

Autolearn Zero 
LAN IPX Nets 

 

By setting this parameter to Enable, FCD-IPM learns IPX Nets from 
RIP/SAP frames sent by other IPX routers on the same LAN. Refer to 

. If there are no other IPX routers on FCD-IPM LAN, this 

parameter must be set to Disable, and you must configure the IPX Nets 
for each frame type.