RAD Data comm Modular Access Device with Integrated Router Manuel D’Utilisation

Chapter 5  Setup Menu 

FCD-IPM Installation and Operation Manual 

5-88 

WAN Economy Menu

 

 

Interface 

 

Area where the filters will act. If you want to filter traffic 

going to the LAN, choose LAN. If you want to filter traffic 
going to the link, choose Link. 

Source Address   

Toggle to the desired address type (MAC or NET). The 

address format (hexadecimal or binary) appears. Type in 
the complete source address.  
If you want to include a group of addresses, type <x> to 

indicate "Don't care". For example, a filter with the MAC 
source address the 4020.D2FE.xxxx will pass any address 

beginning with 4020.D2FE. You select IP RANGE to filter a 

group of sequential IP addresses. 

Destination 

Address 

 

Toggle to the desired address type. The address format 

(hexadecimal or binary) appears. Type in the complete 

destination address. Choose True or False. 
Normally, a frame has a particular destination, as specified 

in the destination address field of the frame. Such frames 

are referred to as "All" frames. "BroadCast" frames are 
intended for all stations. If you specify "BroadCast" do not 

specify a mask pattern. Select IP RANGE to filter a group 

of sequential IP addresses. 

High Level 

When you choose this parameter, 2 choices appear:Yes 

and No.  

When Yes is chosen, a list of High Level protocols appear. 
The High Level protocols include: 

  

Choose True or False for each protocol to be filtered. 

Source/ 
Destination 

Sockets 

This parameter differs for IP and IPX. 
IP

 – The Destination Port is enabled when no High Level 

protocol is specified. If you define a port number in 

decimal numbers, define the low level protocol as UTP or 

. If no port number is defined, define the low level 

protocol as UTP, TCP, or ICMP. Choose True or False 
IPX

 – If a socket address or low level protocol is not 

defined, a socket number may be specified. Choose True 
or False.