RAD Data comm Modular Access Device with Integrated Router Manuel D’Utilisation
FCD-IPM Installation and Operation Manual
Chapter 4 Configuration
Quick Setup Menu
4-3
To view the options:
• Toggle with the space bar and press ENTER.
• Toggle with the space bar and press ENTER.
To enter new information:
1. Type in the new parameters.
2. Press <Enter>.
1. Type in the new parameters.
2. Press <Enter>.
To change the existing value:
• Press <Backspace>.
• Press <Backspace>.
After all parameters have been accepted or changed, you can view them on the
screen. A confirmation message appears requesting that you confirm all the setup
changes. The device may reset after saving these changes.
screen. A confirmation message appears requesting that you confirm all the setup
changes. The device may reset after saving these changes.
To configure the setup parameters:
1. From the Main Menu, select option 1, Quick Setup.
2. Follow the on-screen instructions to accept or modify the setup parameters.
3. Press Y to save the setup parameters.
1. From the Main Menu, select option 1, Quick Setup.
2. Follow the on-screen instructions to accept or modify the setup parameters.
3. Press Y to save the setup parameters.
Quick Setup Parameters
The Quick Setup menu contains both general parameters and those parameters
specific to the interfaces installed. This section organizes the parameters into
various categories. The screen for each interface and a description of the options
in the Quick Setup menu can be found in the sections that follow. Refer to the
section that applies to the interface you ordered.
specific to the interfaces installed. This section organizes the parameters into
various categories. The screen for each interface and a description of the options
in the Quick Setup menu can be found in the sections that follow. Refer to the
section that applies to the interface you ordered.