RAD Data comm Modular Access Device with Integrated Router Manuel D’Utilisation
FCD-IPM Installation and Operation Manual
Chapter 4 Configuration
Quick Setup Menu
4-5
Quick Setup Menu Examples
The following pages illustrate some of the Quick Setup menus, dependent upon
the interface that has been ordered.
the interface that has been ordered.
Quick Setup for T1 (PPP, IP)
shows the Quick Setup menu for T1.
QUICK SETUP
-----------
WARNING: This device automatically exits to Operational
Messages 10 minutes after last keyboard action without
saving parameters
'ENTER' - Accept parameter , 'SPACE' - Change parameter.
WAN interface Link 1 - T1
Link status
: [Enable]
Link mode
: [Synchronous]
Routing
: [IP ROUTER], Protocol: [PPP]
WAN IP address
: 10.0.0.1, enter new : 10.0.0.1
WAN IP mask
: 255.255.255.252, enter new: 255.255.255.252
Do you want to configure the T1 Interface parameters (Y/N)?:
Host IP setup:
LAN Status
: [Enable]
LAN IP address
: 192.168.1.1, enter new : 192.168.1.1
LAN IP mask
: 255.255.255.000, enter new : 255.255.255.000
Default gateway setting by: [Interface]
Default gateway interface: 1
SECURITY Setup
Device access name : FCD-IPM
No password at present – do you want to create password (Y/N)?: [N]
Security type
: [Disabled]
Saving the changes might cause RESET the unit.
Do you want to save QUICK SETUP (Y/N)? Y
Figure 4-2. T1 Interface Quick Setup Screen