MicroNet Technology SP5050 Manuel D’Utilisation

Open debug message will show up specific information while VoIP FXO
gateway is in operation. After executing the debug command, it should
execute command debug -open as well. One example is demonstrated
below.

usr/config$ debug -add h323 vp
usr/config$ debug -open

Parameters

Usage:

-status

Display the enabled debug flags.

-add

Add debug flag.

-- h323 : h323 related information

-- vp : voice related information

-delete

Remove specified debug flag.

-open

Start to show debug messages.

-close

Stop showing debug messages.

5.4 [reboot] command

After commit command, type reboot to reload VoIP FXO gateway in new
configuration. The procedure is as below:

usr/config$ reboot
Attached TCP/IP interface to cpm unit 0
Attaching interface lo0...done
AC4804[0] is OK
AC4804[1] is OK
AC4804[2] is OK
Successful

Initialize OSS libraries...OK!
open stack successful
cmInitialize succeed!
GK mode selected.

login:

5.5 [flash] command

This command will clean the configuration stored in the flash rom and reboot
VoIP FXO gateway in factory default setting.

Parameter Usage:
-clean

clean all the user-defined value, and reboot VoIP FXO gateway
in factory default mode.

Note:

It is recommended that use “flash –clean” after application firmware id
upgraded.