RAD Data comm IPmux-11 Manuel D’Utilisation

IPmux-11 Ver. 2.00 

Configuring IPmux-11 

1 

Installation of IPmux-11 should be carried out only by an experienced technician. 
If you are familiar with IPmux-11, use this guide to prepare the unit for operation. 

1.  Connect the network to the RJ-45 connector designated ETH 1. 
2.  Connect the user LAN(s) to the RJ-45 connector(s) designated ETH 2 or ETH 3. 
3.  Connect the E1 or T1 line to the RJ-45 connector designated E1 or T1. 

 

When connecting balanced E1 or T1 equipment, make sure to use only 4-wire 
RJ-45 connectors with the following pins used for receiving and transmitting data: 
1, 2, 4, 5. Do not use 8-pin RJ-45 connectors.   

 

4.  Connect the control terminal to the rear panel CONTROL connector. 

or 
Connect a Telnet host, or a PC running a Web browsing application to one of 
the user LAN ports. 

•  Connect the power cable to the power connector on the IPmux-11 rear panel. 

The unit has no power switch. Operation starts when the power is applied 
to the rear panel power connector. 

Configure IPmux-11 to the desired operation mode via an ASCII terminal connected 
to the rear panel CONTROL port. Alternatively, you can manage IPmux-11 over 
Telnet, or via a PC running a Web browsing application connected to one of the user 
LAN ports. 

 

To start a terminal session: 
1.  Connect a terminal to the CONTROL connector of IPmux-11. 
2.  Turn on the control terminal PC and set its port parameters to 115,200 baud, 

8 bits/character, 1 stop bit, no parity. Set the terminal emulator to ANSI VT100 
emulation (for optimal view of system menus). 

3.  Power IPmux-11 up and proceed with management session.