RAD Data comm IPmux-11 Manuel D’Utilisation

Quick Start Guide 

Installation and Operation Manual 

2 

Configuring IPmux-11 

IPmux-11 Ver. 2.00 

The host IP address, subnet mask and default gateway IP address must be 
configured via an ASCII terminal. 

 

To configure the IP management parameters: 
•  From the Host IP menu (Main > Configuration > System > Host IP), select 

an IP address of the IPmux-11 host. 

E1 and T1 interface must be configured at the physical level first. 

 

To configure E1 and T1 at the physical level: 
•  From the TDM Configuration menu (Configuration > Physical layer > TDM 

), configure the necessary parameters of the E1 or T1 services. 

The E1/T1 timeslots must be assigned to a bundle. The bundle must be sent to the 
remote IP address and be connected to one of the destination bundles. 

 

To assign timeslots to a bundle: 
•  From the DS0 Bundle Configuration menu (Main > Configuration > 

 > DS0 bundle configuration), assign desired timeslots to a 

bundle by setting them to 1. 

 

To connect a bundle: 
•  From the Bundle Connection Configuration menu (Main > Configuration > 

 > Bundle connection configuration), set the following: 

 

Destination IP address 

 

Destination bundle. 

 

To configure the Ethernet policy for the internal bridge ports: 
•  From the ETH Policy Configuration menu (Main > Configuration > Bridge > 

), do the following: 

 

Specify bridge port operation mode 

 

Set default VLAN ID 

 

Set default VLAN priority 

 

Select rate limit for each port. 

 

To configure VLANs for the internal bridge ports: 
•  From the VLAN Table Configuration menu (Main > Configuration > Bridge 

> VLAN table configuration), assign VLANs for each bridge port, if necessary.