RAD Data comm IPmux-11 Manuel D’Utilisation

Chapter 6  Troubleshooting and Diagnostics 

Installation and Operation Manual 

6-20 Testing 

IPmux-11

 

IPmux-11 Ver. 2.00 

•  Define loop-up code length (Length of the code to be sent by the TDM device 

in order to activate a loopback) 

•  Define loop-up code (Code to be sent by the TDM device in order to activate 

a loopback) 

•  Define loop-down code length (Length of the code to be sent by the TDM 

device in order to deactivate a loopback) 

•  Define loop-up code (Code to be sent by the TDM device in order to 

deactivate a loopback). 

Diagnostics>Loopback (T1)>Inband Loop Detection 

1. Loop Location                 > (Local System) 

2. Loop up length[1 - 8]         ... (5) 

3. Loop up code[Hex]             ... (10) 

4. Loop down length[1 - 8]       ... (3) 

5. Loop down code[Hex]           ... (4) 

 

> 

Please select item <1 to 5> 

ESC-prev.menu; !-main menu; &-exit                                   1 Mngr/s 

You can ping a remote IP host to check the IPmux-11 IP connectivity.  

 

To ping an IP host: 
1.  From the Diagnostics menu (

), select Ping. 

The Ping menu appears (see 

2.  From the Ping menu, configure the following: 

 

Destination IP Address (IP address of the host that you intend to ping): 
0.0.0.0 to 255.255.255.255. 

 

VLAN Tagging: 

 

Enable (VLAN tagging is enabled) 

 

Disable (VLAN tagging is disabled) 

 

VLAN ID: 1–4095 

 

VLAN Priority: 0–7 

 

 

 

Number of frames to send: 1–4. 

3. Select Ping to start sending pings.