Emerson P/N MMI-20019808 Manuel D’Utilisation
10
Micro Motion EtherNet/IP Module
Installation
2.
Connect the configuration cable from your PC to the EtherNet/IP Module.
Note
For information on the Micro Motion Ethernet Config Tool user interface, see the Anybus
Communicator manual.
Communicator manual.
2.4
Final steps
1.
From your browser, login to the EtherNet/IP Module as user admin.
2.
Use the Device Configuration page to configure the EtherNet/IP Module.
3.
Set up I/O at your Ethernet host.
-
If you are not using RSLogix, use your standard method. For information on the
I/O assemblies, see Section B.3.
I/O assemblies, see Section B.3.
-
If you are using RSLogix, select ETHERNET-MODULE - Generic Ethernet Module
and enter the required information. See the following figures.
and enter the required information. See the following figures.
Note
If Comm Format is anything other than INT, the data sizes will be different from the sizes shown.
1
9
5
6
1
2
4
1
PC connector
1) Ground
2) Ground
3) RS-232 Rx
4) RS-232 Tx
2) Ground
3) RS-232 Rx
4) RS-232 Tx