Marantz SR7300OSE Manuel D’Utilisation

Press and hold down the 

and 

buttons until

is displayed in the display.

Press and hold down the 

button and press 

 and

 button.

•

and 

are blinking.

Press 

 button to continue erasing.

•

is displayed for 3 seconds and the mode returns to

LEARN mode.

• To cancel the erasing operation, do not press 

button and

simply touch any other button.

To return the USE mode, press and hold down the 

button

until 

is displayed in the display.

• Erasing codes will return to the factory preset code, or there will

leave empty if the button has no factory preset code.

Macros make it possible to use a single function button to perform
more complex series of operations that would normally require
pressing several buttons. A single button can be programmed to
perform up to 10 steps in sequence. A typical example of such a series
might be as follows:
• Turn the main amplifier power ON 

→

 Switch the function to DVD 

→

Set the Surround Mode to Virtual 

→

 Set the DVD player to PLAY.

• No signals may be transmitted during macro programming.

• The various steps that make up a macro are set initially to be sent

one after another in 1 second intervals, however these intervals
may be shortened to as little as 0.5 seconds or lengthened to as
much as 5 seconds using the Setup mode.

• In the macro mode, the number of steps the macro is displayed the

following selected function name.

• Macros may be programmed for each of the 12 function buttons as

follows;

TV, DVD, VCR1, DSS, TUNER, CD, CDR, MD, TAPE, AUX1,
AUX2, AMP

Press and hold the 

and 

button until the 

is displayed.
 •

and 

indicators are displayed blinking on the

LCD, too.

Press the 

button for which you wish to program a series

of operations.
In this case, let’s use the example of the DVD player.
Press the 

 button. The LCD will display DVD-M.

Characters displayed on LCD include the following, depending on
the function button for which the macro is being programmed:

TV-M, DVD-M, VCR-M, DSS-M, TUN-M, CD-M, CDR-M, MD-M,
TAP-M, AX1-M, AX2-M, AMP-M

• If a macro has already been set for the selected function

button, the LCD will blink.

Press the buttons for the operations you wish to program as a
macro in the sequence you want the macro to program them.
For example, press DVD, PLAY.
• The number of steps in the macro is displayed on LCD and

this number increases by 1 with each button pressed.

• Each function button can be programmed to perform up to 10

steps in sequence.