Black Box ACXIO8-SM Manuel D’Utilisation

Page 102

724-746-5500 | blackbox.com

Chapter 5: Operation

NOTE: You can only use the hotkeys to switch to unused and allowed CPUs.

Hotkeys are only supported if neither “Enable User Login” nor “Enable User
ACL” is selected and the user is logged in the OSD.

5.1.2 Scan Mode

The Scan Mode can show video signals of the different CPUs fast and without
delay and switch continuously using the hotkey. Switching between two video
signals can even take place within one frame.

1. Start command mode with the hotkey. For control, the “Shift” and “Scroll”

LEDs flash at the keyboard if command mode is activated.

2. Press the “<Left Shift>” key and hold it down. You can now enter the index

numbers of the various CPUs from the list of favorites with the keyboard and
immediately switch to the video signal of the respective CPU after entering the
index number.

3. Leave Scan Mode by pressing “<Left Shift> + <Esc>.”

NOTE: For optimal results, use identical resolutions. This contributes to a smooth

and delay-free scan mode function.

5.1.3 Addressing Master and Slave

The ServSwitch DKM FX can be cascaded in two steps. You can optionally send
the commands (including opening the OSD) to the master or the slave matrix.

Whenever command mode is activated, you can select by a <m> or a <s>, if all
the following commands should be handled in the master or in the slave matrix.

OSD Access

• OSD access to the master matrix:

<Left Shift>, <Left Shift>, <m> (optional), <o>

• OSD access to the slave matrix:

Example: Switching to the CPU Port 23 of the slave matrix.

1. Switching to the CPU port (e.g. 12) of the master matrix that has the

connection to the slave matrix:

<Left Shift>, <Left Shift>, <m> (optional), <1>, <2>, <Enter>