FieldServer FS-8704-16 Manuel D’Utilisation
FS-8704-16 Omron FINS Manual
Page 14 of 37
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com
4.1.9.
Map Descriptor Example 6: Run-Stop PLC:
Defining this Map Descriptor Driver can change the PLC mode to STOP (Program), MONITOR or RUN mode. The
Driver issues a change mode command to the PLC whenever the value at the declared offset is updated.
Driver issues a change mode command to the PLC whenever the value at the declared offset is updated.
Map_Descriptor_Name,
Data_Array_Name,
Data_Array_Offset,
Function,
Node_name
Length
Command_Name
Unit_Number
CMD_RUN_ST,
DA_RUN_ST,
0,
WRBX,
PLC1,
1,
RUN-STOP
0s
The Driver will change PLC modes depending upon the value poked by the upstream device at offset (0 in this case).
See section Appendix B.1 for values corresponding to PLC modes.
See section Appendix B.1 for values corresponding to PLC modes.
4.1.10.
Map Descriptor Example 7: Read CPU Status:
Defining this Map Descriptor Driver reads the CPU status and stores it in the Data Array DA_STATUS.
Map_Descriptor_Name,
Data_Array_Name,
Data_Array_Offset,
Function,
Node_name
Length
Command_Name
Unit_Number
CMD_STATUS,
DA_STATUS,
0,
REBC,
PLC1,
67,
CPU UNIT STATUS READ
0s
The Driver stores the status information in the named Data Array at consecutive locations starting with
Data_Array_Offset.
Data_Array_Offset.
See Appendix B.1 for further information.