Benq VA261 Manuel D’Utilisation

Section 1: Quick Start Guide

5

 Test the remote control

6. View the TV channels 

Press Power 

 on the remote control (as highlighted in the 

illustration). The TV should turn on, and the power indicator change to 

green. If so, progress to the next step 

 below.

If the TV does not turn on, first check that the power is available 

 

(the power indicator will be lit red). 

 

If so, try pressing Power on the right side of the TV. If the TV turns 

on by this method, the problem lies with the remote control.
In that case, check that the remote control batteries are properly 

installed. If need be, replace the batteries with new or known good 

ones. See 

 for further assistance.

To turn off the TV, press Power on the right side of the TV, or Power on 

the remote control again, and the TV will return to standby mode (the 

power indicator will turn red.)

Turn the TV on and select 'TV' as the input by pressing INPUT. The 

channel number will display in the upper right corner of the TV screen. 

 

See 

.

This TV series is factory set for Australia. It already has the Australian 

TV station channels pre-tuned ready for instant use. If you purchased 

this TV for use in Australia, it is ready to operate out of the box.

 

To change to a channel directly, select the channel number using the 

numeric channel selection buttons on the remote control (as 

highlighted in the illustration). For example:

• to select channel 8, press 

. 

• to select channel 28, press 

, 

.

 See 

By default, all of the possible Australian TV channels are added to the 

sequential channel list (available through the Channel up or down 

buttons). You should perform the 'Auto installation' setup so that only 

the channels available in your local area are added to the sequential 

channel list (and all others are skipped). 

 

See 

To change to the next channel in the sequential channel list:

• Press CHANNEL   or CHANNEL  on the remote control (as 

highlighted in the illustration) or CH  or CH on the TV.

To return to the previous viewed channel or input, press RECALL (also 

highlighted in the illustration).