Toshiba 8GHO44-88 Manuel D’Utilisation

 

36

 

 

– Does not sequence through cameras that have 0 FPS specified. 

 

– Opens the Audio ENABLE/DISABLE options. 

  

– Opens the TV Out setup options. 

 

 

– Opens the Volume controls that affect the Audio Recording levels. 

 
 
4.7.1 Voice 

 
The DVR unit allows you to play a sound file when either a Motion event or Sensor event occurs. This file can be a 
custom created sound file that is unique to your application. The selected WAV file is played through speakers attached 
to the DVR unit.  
 
 
 
 
 
 
 
 
 
 
 
 

 

– Displays the Audio file that will be used during the Voice Warning Event. 

 

– Allows you to select the location of the WAV file to use. Note – Only WAV files are supported.  

 

– Plays the selected WAV file. 

 

– Enables the Voice Warning on Motion Events. 

 

– Enables the Voice Warning on Sensor Events 

 

 
 

 
The DVR supports a Video Loss Alarm function which allows an Alarm Event to occur when a camera loses signal. The 
lost signal can be due to Power failure to the camera, the camera cable being cut or unplugged, or the camera being 
damaged in some way.  
 
In order to use Video Signal Loss detection, cameras must either be turned ‘ON’ or ‘OFF’. This is because the DVR 
needs to know which cameras it should expect to receive signals from. To turn camera(s) ‘ON’, open FRAME SETUP, 
and set the Frames Per Second to anything above zero. By designating zero frames per second you are essentially 
saying that the camera is not going to be used by the DVR. 
 
 

 

– When Video Loss 

occurs an internal speaker on the DVR will 
sound an alarm. 

– When Video Loss 

occurs, the Alarm Output is activated. 

– Records the Video 

Loss Alarm events to the Log Files.  

Figure 4.7.1 

Figure 4.7.1 

Figure 4.7.2 

Figure 4.7.2