Winegard RTS-80B Manuel D’Utilisation

7. Clean roof area where the base feet will be 

attached to the roof. Do not erase your marks!

8. Put approved sealant in the areas marked 

for the base feet. Place base feet on top of the 

sealant and screw down with the (3) #10 screws 

for each foot. 

9. After all base feet are secured to roof, put 

sealant around edge of feet and over screws. 

6. 

Place the unit on the roof in its permanent loca-

tion and mark around each base foot, Figure 3. 

1. Connect the quick disconnect power cable to the 

panel mount on the back of the RoadTrip Minimax 

unit. See Figures 4 & 5 below.     

!

CABLE-

ENTRy 

CABLE CLAMPS 

PRIMARY          

RECEIVER

RoAdTRIP 

MInIMAx

SECondARY 

RECEIVER

Decide the best location for the power and coax 

cables to enter the vehicle, and the location of the 

power switch and receiver. Drill a 3/4” hole in the 

roof, push wires inside. 

2. Connect the Primary receiver to the Primary 

Port on the panel mount.
3. For a two receiver installation, connect 

a second coax cable (not provided) to the 

SECONDARy connector on base and run cable 

along roof to second receiver location.
4. Place cable-entry plate over hole and cables. 

Screw in place. Seal plate and screw holes with 

approved sealant (not included).
5. Depending on the length of the cable on the 

roof, you may need to use cable clamps or wire 

ties (not provided) between the unit and your 

cable-entry plate. Clamping the cable every 12”-

16” should eliminate any unnecessary cable 

movement, Figure 6.