Sunrise Medical Quickie P120 Manuel D’Utilisation

930373 Rev. B

I X .

S E T U P ,

A D J U S T M E N T & U S E

K. REAR WHEEL LOCKS (OPTIONAL)
When requested, rear wheel locks are
installed by Sunrise.

1. Note: Use a torque setting of 70-80 inch-

pounds to tighten wheel lock bolts.

2.To Adjust:

a. Use a open-end wrench to loosen two

bolts (8) on top clamp (6).

b. Turn each bolt counter-clockwise one-

quarter turn; (Alternate, to keep bolts
from binding).

c. Adjust (6) clamp toward rear wheel until

lock arm (7) embeds in tire at least 1/8”
when locked.

d. Alternate as you retighten bolts (8).

e. Repeat steps on other side.

I X .

S E T - U P ,

A D J U S T M E N T & U S E

I. FLIP-BACK ARMRESTS

1.Notes:

Non-removable, we install this armrest at
the factory.

2.To Flip Armrest Back:

Push latch lever (1) toward tube to “flip”
or tilt armrest back.

J. FLIP-BACK HEIGHT-

ADJUSTABLE ARMRESTS
(OPTIONAL)

1.Notes:

Armrest are removable; you can adjust the
height of the armrest pad.

2.To Flip Armrest Back:

Push latch lever (2) toward tube to “flip”
or tilt armrest back.

3.To Remove:

a. Push latch lever (2) toward tube and

“flip” or tilt armrest back.

b. Pull up on armrest pad.

4.To Height Adjust:

a. Press release lever (5)

b. Pull up on the armrest pad to the

desired location.

5.To Replace:

a.Tilt armrest back and insert rear arm

tube (3) into receiver (4).

b.Tilt armrest forward.This will engage pin

to secure rear arm tube.

c. Push armrest down until front tube locks

in place.