Manuel D’UtilisationTable des matièresBEFORE YOU BEGIN...................................................................................... 12IMPORTANT SAFETY NOTICES..................................................................... 22HARDWARE PACK……….....…....................................................................... 42ASSEMBLY INSTRUCTIONS........................................................................... 72EXPLODED DIAGRAM.........................................................................………. 182PARTS LIST………………………………………………………………………….. 202WARRANTY.................................................................................................… 212ORDERING PARTS......................................................................................... 212HARDWARE PACK6HARDWARE PACK7ASSEMBLY INSTRUCTION8Note: Do not tighten the Nuts and Bolts until instructed to do so.12Attach the top of Left Support (#2) to an Upright Beam (#1). Secure it with two M10 x 5/8” Allen Bolts (#82) and Ø ¾” Washers (#69).12Attach the Left Floor Stabilizer (#4) to the Upright Beam. Secure it with one M10 x 4” Carriage Bolt (#73), ( ¾” Washer (#69), and M10 Aircraft Nut (#72).12Attach the other end of the Left Floor Stabilizer (#4) and Rear Stabilizer (#7) to the bottom of Left Support (#2). Align the holes and secure them together with one M10 x 2½” Carriage Bolt (#74), Ø ¾” Washer (#69), and M10 Aircraft Nut (#72) to the uppe12Repeat procedure B, C, and D above to install the other side.12Connect the Left & Right Supports (#2 & 3) with the Cross Brace (#6). Secure each end with two M10x2½” Carriage Bolts (#74), ؾ” Washers (#69), and M10 Aircraft Nuts (#72).12PARTS LIST21KEY NO. DESCRIPTION Q’ty21Taille: 2,8 MoPages: 22Language: EnglishOuvrir le manuel