Manuali utente per Impex MD-11.0

Sommario

• BEFORE YOU BEGIN...................................................................................... 1

  2
• IMPORTANT SAFETY NOTICES..................................................................... 2

  2
• HARDWARE PACK……….....…....................................................................... 4

  2
• ASSEMBLY INSTRUCTIONS........................................................................... 7

  2
• EXPLODED DIAGRAM.........................................................................………. 18

  2
• PARTS LIST………………………………………………………………………….. 20

  2
• WARRANTY.................................................................................................… 21

  2
• ORDERING PARTS......................................................................................... 21

  2
• HARDWARE PACK

  6
• HARDWARE PACK

  7
• ASSEMBLY INSTRUCTION

  8
  • Note: Do not tighten the Nuts and Bolts until instructed to do so.

    12
  • Attach the top of Left Support (#2) to an Upright Beam (#1). Secure it with two M10 x 5/8” Allen Bolts (#82) and Ø ¾” Washers (#69).

    12
  • Attach the Left Floor Stabilizer (#4) to the Upright Beam. Secure it with one M10 x 4” Carriage Bolt (#73), ( ¾” Washer (#69), and M10 Aircraft Nut (#72).

    12
  • Attach the other end of the Left Floor Stabilizer (#4) and Rear Stabilizer (#7) to the bottom of Left Support (#2). Align the holes and secure them together with one M10 x 2½” Carriage Bolt (#74), Ø ¾” Washer (#69), and M10 Aircraft Nut (#72) to the uppe

    12
  • Repeat procedure B, C, and D above to install the other side.

    12
  • Connect the Left & Right Supports (#2 & 3) with the Cross Brace (#6). Secure each end with two M10x2½” Carriage Bolts (#74), ؾ” Washers (#69), and M10 Aircraft Nuts (#72).

    12
• PARTS LIST

  21
• KEY NO. DESCRIPTION Q’ty

  21