Manuels d'utilisation pour Impex WM-354

Table des matières

• BEFORE YOU BEGIN...................................................................................…. 1

  2
• IMPORTANT SAFETY NOTICES..................................................................…. 2

  2
• HARDWARE IDENTIFIER.....…....................................................................…. 3

  2
• ASSEMBLY INSTRUCTIONS........................................................................…. 4

  2
• EXPLODED DIAGRAM………………………………………………………………. 9

  2
• PARTS LIST...............................................................................................……. 10

  2
• WARRANTY.................................................................................................…. 11

  2
• ORDERING PARTS.......................................................................................… 11

  2
• ASSEMBLY INSTRUCTION

  5
  • Attach one (3/4” Washer (#31) onto a M10 x 6” Hex Bolt (#35). Insert the Bolt through the Butterfly (#9). Secure the Bolt with one M10 x 5/8” Regular Nut (#36)

    7
  • Insert the Bolt through the Rear Upright Beam (#1). Secure it with a Ø ¾” Washer (#31) and M10 Aircraft Nut (#32). DO NOT over tighten the Bolt. Make sure the Butterfly is able to swivel on the Upright Beam.

    7
  • Insert a Butterfly Foam Tube (#10) through the hole on the Butterfly. Push a Foam Roll (#20) onto the Tube. Place a Spring Clip (#23) onto the weight post on the Butterfly.

    7
  • Repeat above procedures A, B and C to install the other side.

    7
  • Attach the Leg Developer (#11) to the Front Leg (#8). Secure it with one M8 x 3 1/8” Hex Bolt (#27), two Ø 5/8” Washers (#28), and one M8 Aircraft Nut (#29).

    7
  • Insert two Foam Tubes (#12) halfway through the holes on the Leg Developer. Push four Foam Rolls (#20) onto the Tubes from both sides.

    7
  • Place a Spring Clip (#23) onto the weight post on the Leg Developer.

    7
  • Attach the hole-side of the Backrest Supports (#14) onto both ends of the pivot on the Main Seat Support (#6). Place the other end rest against the Backrest Adjustment Bar (#4).

    8
  • Place the Backrest Board (#15) onto the Backrest Supports. Secure it with four M6 x 1 3/8” Hex Bolts (#37) and Ø ½” Washers (#38).

    8
  • Place the Seat Pad (#16) onto the Main Seat Support. Secure it with four M6 x 1 3/8” Hex Bolts (#37) and Ø ½” Washers (#38).

    8
    • DIAGRAM 4

      8
  • Attach the Arm Curl Pad (#17) to the Arm Curl Stand (#13). Secure it with two M8 x 5/8” Hex Bolts (#33) and Ø 5/8” Washers (#28).

    9
  • Insert the Arm Curl Stand into the top opening on the Front Leg. Secure it with a Lock Knob (#25).

    9
    • DIAGRAM 5

      9
  • 20 Foam Roll 6

    11