Manuale UtenteSommarioBEFORE YOU BEGIN...................................................................................…. 12IMPORTANT SAFETY NOTICES..................................................................…. 22HARDWARE IDENTIFIER.....…....................................................................…. 32ASSEMBLY INSTRUCTIONS........................................................................…. 42EXPLODED DIAGRAM………………………………………………………………. 92PARTS LIST...............................................................................................……. 102WARRANTY.................................................................................................…. 112ORDERING PARTS.......................................................................................… 112ASSEMBLY INSTRUCTION5Attach one (3/4” Washer (#31) onto a M10 x 6” Hex Bolt (#35). Insert the Bolt through the Butterfly (#9). Secure the Bolt with one M10 x 5/8” Regular Nut (#36)7Insert the Bolt through the Rear Upright Beam (#1). Secure it with a Ø ¾” Washer (#31) and M10 Aircraft Nut (#32). DO NOT over tighten the Bolt. Make sure the Butterfly is able to swivel on the Upright Beam.7Insert a Butterfly Foam Tube (#10) through the hole on the Butterfly. Push a Foam Roll (#20) onto the Tube. Place a Spring Clip (#23) onto the weight post on the Butterfly.7Repeat above procedures A, B and C to install the other side.7Attach the Leg Developer (#11) to the Front Leg (#8). Secure it with one M8 x 3 1/8” Hex Bolt (#27), two Ø 5/8” Washers (#28), and one M8 Aircraft Nut (#29).7Insert two Foam Tubes (#12) halfway through the holes on the Leg Developer. Push four Foam Rolls (#20) onto the Tubes from both sides.7Place a Spring Clip (#23) onto the weight post on the Leg Developer.7Attach the hole-side of the Backrest Supports (#14) onto both ends of the pivot on the Main Seat Support (#6). Place the other end rest against the Backrest Adjustment Bar (#4).8Place the Backrest Board (#15) onto the Backrest Supports. Secure it with four M6 x 1 3/8” Hex Bolts (#37) and Ø ½” Washers (#38).8Place the Seat Pad (#16) onto the Main Seat Support. Secure it with four M6 x 1 3/8” Hex Bolts (#37) and Ø ½” Washers (#38).8DIAGRAM 48Attach the Arm Curl Pad (#17) to the Arm Curl Stand (#13). Secure it with two M8 x 5/8” Hex Bolts (#33) and Ø 5/8” Washers (#28).9Insert the Arm Curl Stand into the top opening on the Front Leg. Secure it with a Lock Knob (#25).9DIAGRAM 5920 Foam Roll 611Dimensioni: 1,89 MBPagine: 12Language: EnglishApri il manuale