Manuels d'utilisation pour Pressure Systems 9046

Table des matières

• Introduction

  1
• General

  1
• 1.1.1 Introduction

  1
• 1.1.2 Physical Description

  2
• 1.1.3 Theory of Operation

  3
• 1.1.3.1 Thermocouple Cold Junction Compensation

  3
• 1.1.3.2 Open Circuit Detection

  4
• Setup Instructions

  4
• Equipment Required

  5
• Computer Preparation

  6
• Module Connection

  8
• IP Address Assignment

  10
• Set Sensor Type

  14
• Read Sensor Type

  16
• Thermocouple Reference Temperature Alarms

  16
• Set Temperature Units

  18
• Read Temperature Units

  18
• Write EU Filter Parameter

  18
• Read EU Filter Parameter

  20
• Calibration

  21
• Firmware

  23
• Description of Operation

  23
• Updating the Firmware

  25
• Command Set

  27
• Summary Information About All Commands

  29
• No Operation (Command ‘A’)

  32
• Reset (Command ‘B’)

  33
• Read Primary Transducer Volts (Command ‘V’)

  34
• Read Primary Transducer A/D Counts (Command ‘a’)

  36
• Read Primary Transducer E.U. Data at High Speed (Command ‘b’)

  38
• Define/Control Autonomous Host Streams (Command ‘c’)

  40
• 5.7.1 Sub-command Index 00: Configure a Host Delivery System

  43
• 5.7.2 Sub-command Index 01: Start Stream(s)

  48
• 5.7.3 Sub-command Index 02: Stop Stream(s)

  50
• 5.7.4 Sub-command Index 03: Clear Stream(s)

  52
• 5.7.5 Sub-command Index 04: Return Stream Information

  54
• 5.7.6 Sub-command Index 05: Select Prefix/Data Groups in a Stream

  56
• 5.7.7 Sub-command Index 06: Select Protocol for Stream Delivery

  59
• Appendix A

  63