Land Pride rcf3696 Manuale Utente

48

12/15/15

Clean, inspect, service, and make necessary repairs to 
the cutter when parking it for long periods and when 
parking it at the end of a working season. This will help 
ensure the cutter is ready for field use the next time you 
hook-up to it.

1.

Clean off any dirt and grease that may have 
accumulated on the cutter and moving parts. Scrape 
off compacted dirt from the bottom of deck and then 
wash surface thoroughly with a garden hose. A 
coating of oil may also be applied to the lower deck 
area to minimize oxidation.

2.

Check blades and blade bolts for wear and replace if 
necessary. See “Cutter Blade Maintenance” on 
page 43.

3.

Inspect for loose, damaged or worn parts, and adjust 
or replace as needed.

4.

Repaint parts where paint is worn or scratched to 
prevent rust. Ask your Land Pride dealer for aerosol 
touch-up paint. Paint is also available in touch-up 
bottles with brush, quarts, and gallon sizes by adding 
TU, QT, or GL to the end of the aerosol part number.

Part No.

Part Description

821-011C

PAINT LP BEIGE SPRAY CAN

821-002C

PAINT GP BLACK SPRAY CAN

821-054C

PAINT MEDIUM RED SPRAY CAN

821-058C

PAINT GREEN SPRAY CAN

821-066C

PAINT ORANGE AEROSOL SPRAY CAN

5.

Replace all damaged or missing decals.

6.

Lubricate as noted in “Lubrication” on page 49.

7.

Store cutter on a level surface in a clean, dry place. 
Inside storage will reduce maintenance and make for 
a longer cutter life.

8.

Follow all unhooking instructions on page 41 when 
disconnecting tractor from cutter.

Land Pride offers equipment in factory standard beige 
color with black highlights. Equipment in special colors 
may be purchased in Green, Red, or Orange. Because of 
the variety of colors available, special attention must be 
given to the part number to prevent ordering the wrong 
replacement part. A suffix number corresponding to one 
of the colors below must be added at the end of Land 
Pride’s part number when ordering a replacement part 
with that color. Parts ordered without a suffix number will 
be supplied in factory standard colors.

For example, if you are ordering a replacement part with 
part number 555-555C and the existing part is red, then 
add the suffix 83 to the end of the number to make the 
part number read 555-555C83.