Impex MACH V Manuale Utente

STEP 13   (See Cable Loop Diagram & Diagram 13) 
A.)  Attach one end of the 78” Bench Press Cable (#54) to a Single Floating Pulley Bracket (#35). 

Secure it with one M10 x 1” Allen Bolt (#114), two Ø ¾” Washers (#124), and one M10 Aircraft 
Nut (#128).  Let the Bracket hanging for now. 

B.)  Pull the Cable upward to the opening between the Bench Press Base (#14). Attach a Pulley to 

the opening. Secure it with one 7” Axle (#130) and two M8 Hex Socket Screws (#82). 

C.)  Draw the Cable around the Pulley then pull downward to the third open bracket on the Main 

Base Frame (#1). Attach a Pulley and a L-shaped Pulley Bracket (#46) to the bracket. 

D.)  Secure the Pulley with one M10 x 1 ¾” Allen Bolt (#113), two Ø ¾” Washers (#124), and one 

M10 Aircraft Nut (#128).   

E.)  Draw the Cable underneath the Pulley and through the opening underneath the second Pulley 

previously installed.  Draw the Cable to the first open bracket on the Main Base Frame (#1).  
Repeat Step D above to install another Pulley. 

F.)  Draw the Cable around the Pulley then pull upward to the Single Floating Pulley Bracket (#35) 

previously installed in Step10-C. Secure the Cable with one M10 x 1” Allen Bolt (#114), two Ø 
Washers (#124), and one M10 Aircraft Nut (#128).