Impex MACH V Manuale Utente

 

A.) Attach the 163” Lower Cable (#53) to the Swivel Frame (#11).  
B.) Install a Pulley to the bracket on the Swivel Frame with one M10 x 1 ¾” Allen Bolt 

(#113), two Ø ¾” Washers (#124), one L-shaped Bracket (#46) and one M10 Aircraft 
Nut (#128). 

C.) Draw the Cable around the Pulley then pull upward to the Double Floating Pulley 

Bracket (#36) previously installed in Step12-E. Install another Pulley. 

D.) Draw the Cable around the Pulley then pull downward to the first open bracket on the 

left. Repeat the Step B above to install a Pulley with a U-shaped Pulley Bracket (#47). 

E.) Draw the Cable around the Pulley then pull upward to the Single Floating Pulley 

Bracket (#35) previously installed in Step 13-A. Repeat Step B above to install a Pulley. 

F.) Draw the Cable around the Pulley then pull downward to the open bracket on the Main 

Base Frame. Repeat Step B above to install a Pulley with a L-shaped Pulley Bracket 
(#46). 

G.) Draw the Cable underneath the three Pulleys previously installed in Step 13 and 

through the opening on the bottom of the Front Vertical Beam (#7). Continuously draw 
the Cable underneath the Small Pulley Wheel (#65) on the Main Base Frame to the 
opening on the Front Support Frame (#3). Attach a Pulley to the opening. Secure it with 
one M10 x 2 ½” Allen Bolt (#117), two Ø 7/8” Pulley Bushings (#70), and one M10 
Aircraft Nut (#128). 

H.) Draw the Cable over the Pulley and to the open bracket on the Main Seat Support (#2). 

Repeat Step B above to install a Pulley. 

I.)  Draw the Cable through the opening on the Main Seat Support to the open bracket on 

the Leg Developer (#26). Secure the end of Cable with one M10 x 1” Allen Bolt (#114), 
two Ø ¾” Washers (#124), and one M10 Aircraft Nut (#128). 

J.)  Use a C-clip (#136) to connect a Long Chain (#135) to the end of the Cable. Use 

another C-clip to connect the Shiver Bar (#24), Single Handle (#61), or Ankle Strap 
(#60) for various exercises.