Go-Video 9100 Manuale Utente

CHAPTER 3 - INITIAL SETTINGS    

Your Dual-Deck VCR will automatically tune in all available
TV Stations whether from Antenna reception or Cable
(CATV). Simply indicate the Antenna Source and then run
Auto Program:

Press 

MENU

 until the DUAL-DECK FEATURES menu

appears.

Press “1” to select VCR SETTINGS/SET CLOCK.

Press “2” to select TUNER/CHANNEL LIST.

Press 

 repeatedly to set the ANTENNA SOURCE to

Antenna or Cable.

Press 

 or 

 to move the selection arrow to AUTO

PROGRAM.

Press 

 to begin Auto Program. The VCR will cycle

through all possible TV or cable channels and automati-
cally place the channels you receive into Channel
Memory. This will take a few minutes to complete.

Press 

QUIT

 to exit the menu system or 

MENU

 to return to

the VCR SETTINGS menu.

our channel list must have a minimum

of 2 channels; one channel is not valid.

f you are using a cable converter

box, you will need to set your VCR’s
tuner channel to receive only the cable
converter box output channel (see p.39).

• Tuning with the Channel Up/Down Buttons

Press the 

CHANNEL

 Up/Down buttons on the remote control or

on the Dual-Deck VCR’s front panel to move up or down to
the desired channel.

• Tuning with the Number Buttons

For channels 1 through 9, press “0” then press the correspond-
ing number button (1-9). If you are tuning to a channel higher
than 100, press 

100+

 and then enter the last two digits.

• Selecting Line 1 or Line 2

You can select Line 1 or Line 2 with the 

CHANNEL

 Up/Down

buttons. Line inputs are located after the highest pro-
grammed station and before the lowest programmed station.
When you select Line 1 or Line 2, you will see the input (if
any) from additional video equipment connected to your
Front or Rear Audio/Video inputs.

You can change channels with

the Channel Up/Down buttons or

directly with the number keys.