Go-Video 9100 Manuale Utente

CHAPTER 4 - COPY FEATURES    

Copying tapes is what owning a Dual-Deck VCR is all about.
Just follow these simple steps:

Insert your source tape into Deck 1 on the left side of the
Dual-Deck VCR.

Insert your target tape into Deck 2 on the right side of
your VCR.

Press 

COPY TAPE

 on the front panel of your Dual-Deck VCR

or on your remote control. Your Dual-Deck VCR will
begin copying from Deck 1 to Deck 2.

Note: When you press Copy Tape, Deck 1 rewinds a few

seconds (called “pre-roll”) and Deck 2 goes into
Record Pause mode automatically before copying
begins. This “synchro-start” results in the best
possible quality when copying and editing.

To pause the copying process, press 

COPY TAPE

. To resume,

press 

COPY TAPE

 again. To stop the copying process, press

STOP

 on Deck 2.

EZ-Copy automates every step of the Copy Tape process: At
the touch of a button, your Dual-Deck VCR automatically
rewinds both tapes, copies the entire tape from Deck 1 to
Deck 2, rewinds both decks again and ejects the tapes. To
activate EZ-Copy.

Press 

MENU

 until the DUAL-DECK FEATURES menu

appears.

Press “2” to select COPY TAPE SETTINGS.

Press “3” repeatedly to set EZ-COPY to:

On - EZ-Copy is enabled. To activate, simply insert

your tapes and
press the

COPY TAPE

 button.

Off - EZ-Copy is

disabled.

Turn EZ-Copy on or off in the

Copy Tape Settings menu

 f EZ-Copy ends without rewinding

and ejecting the tape then a problem
occurred during the copy. Most likely
the tape in Deck 2 was not long enough
to record the entire source tape.

The Copy Tape button

is your key to one-

touch copies.