Go-Video 9100 Manuale Utente

CHAPTER 7 - EDITING FEATURES    

Play the source tape in Deck 1 to the beginning of the
first scene (in our example this is tape counter position
0:01:08). Press the 

BEGIN

 key to mark the beginning of

the scene.

Play the tape to the end of the scene (in our example this
is tape counter position 0:03:34). Press the 

END

 key to

mark the end of the scene.

Note: After you program each scene, the next scene

number will blink indicating it’s ready to be
programmed.

Press the number for the next scene you want to
program (in our example, scene 2).

Repeat steps 4-6 until all scenes are programmed.

Press 

STOP

 to stop the tape in Deck 1.

Note: You cannot eject the tape in Deck 1 with the

remote control if there are scenes in the Edit List.

Load a blank tape into Deck 2.

Press the 

COPY TAPE

 key. The Dual-Deck VCR will automati-

cally copy each scene from Deck 1 to Deck 2 in the order
programmed.

When editing is complete, stop Deck 2.

You can also perform assembly editing manually, also known
as Sync (Synchronized) Editing.

Note: For best results when Sync editing, be sure to:

• Turn on the On-Screen Display (p.12)

• Turn off EZ-Copy (p.19)

• Turn off Auto Play (p.23)

Insert the source tape into Deck 1.

Insert the target tape into Deck 2.

Press 

DECK 2

 to select Deck 2.

Play the target tape in Deck 2 to approximately 3
seconds after the end of the last frame of the last scene,
then press 

PAUSE/STILL

.

Press 

RECORD

 for Deck 2. This puts the deck into Record

Pause mode.

Press 

DECK 1

 to select Deck 1.

Play the source tape in Deck 1 to the beginning of the
desired scene and press 

PAUSE/STILL

. The Copy Tape button

will blink.

Push 

COPY TAPE

 to begin editing.

The source tape will copy onto the target tape until you
press 

STOP

 on Deck 2, or 

COPY TAPE

 again to make additional

Sync Edits.

The Copy Tape Button makes

Sync Editing a snap