3M 2550 Manuale Utente

 44 

78-9000-0192-2 Rev C

D. Dual Marker Locate

Step 1.  Press Menu/OK [5:Toggle to LOCATE 

MENU display].

Step 2.  Press Marker [SK]. 
Step 3.  Press Markr1 [SK Toggle] to select desired 

Utility.

Step 4.  Press Markr2 [SK Toggle] to select desired 

utility.

Enabling/Disabling Marker Types. When scanning for markers, the Gain Level [7] 

 

− The third and fourth soft key commands will populate with the types of 

utilities selected for Marker 1 and Marker 2.

Step 5.  Adjust the Gain [3] downuntil the Bar Graphs [11] ([10] for 2550 locator) open.

 

− The Bar Graph [11] ([10] for 2550 locator) will close, the audio will 

increase, and the Signal Strength [9] ([8] for 2550 locator) will increase 

when the receiver detects a marker of the specified utility.

 

− When one of the two markers is detected, press the “XXX Only” [SK] for 

the detected utility marker. (“XXX” represents the marker types selected. In 

the above example, PWR Only and TEL Only.)

 

− The receiver will switch to Single Marker Locate in order to pinpoint the 

marker (maximize the Signal Strength [9] ([8] for 2550 locator).

Step 6.  Press Markr2 [SK Toggle] to return to Dual Marker Locate.

E. 3M

™

 iD Marker Depth

Step 1.  Lower the tip of the receiver to the ground over the pinpointed marker.

Step 2.  Press DEPTH [4].

 

− The receiver will examine the marker 

(Calculating, please wait...)

 

− If the marker is a 3M

™

 iD Marker, the 

receiver will display the depth of the 

marker, and its identification (serial) 

number.