JVC GR-DVX709SH Manuale Utente
EN
81
Master Page: Right-Heading0
GR-DVX709SH_80-103.fm
Page 81
DETAILS
ITEMS
NOTES
V Power (
墌 pg. 10)
● Perform charging where the temperature is between 10°C and 35°C. 20°C to
25°C is the ideal temperature range for charging. If the environment is too cold,
charging may be incomplete.
charging may be incomplete.
● Charging times noted above are for a fully discharged battery pack.
● Charging time varies according to the ambient temperature and the status of the
battery pack.
● To avoid interference with reception, do not use the AC Adapter near a radio.
● Since the AC Adapter processes electricity internally, it becomes warm during
use. Be sure to use it only in well-ventilated areas.
● The following operation stops charging:
•Set the Power Switch to “P”, “A” or “M”.
•Disconnect the AC Adapter from the camcorder.
•Unplug the AC Adapter from the AC outlet.
•Detach the battery from the camcorder.
•Disconnect the AC Adapter from the camcorder.
•Unplug the AC Adapter from the AC outlet.
•Detach the battery from the camcorder.
V VIDEO
RECORDING
(
RECORDING
(
墌 pg. 19, 20)
● When you use the LCD monitor outdoors in direct sunlight, the LCD monitor
may be difficult to see. If this happens, use the viewfinder instead.
● The cassette holder cannot be opened unless a power supply is attached.
● There may be a delay after you open the cassette holder cover until the cassette
holder opens. Do not use force.
● Once the cassette holder is closed, it recedes automatically. Wait until it recedes
completely before closing the cassette holder cover.
● When the Recording Start/Stop button is pressed, it may take a few seconds
before actual recording starts. The “T” indicator starts rotating when the
camcorder actually starts recording.
camcorder actually starts recording.
● The time required to calculate and display the remaining tape length, and the
accuracy of the calculation, may vary according to the type of tape used.
● “TAPE END” appears when the tape reaches its end, and the power goes off
automatically if left in this condition for 5 minutes. “TAPE END” also appears
when a cassette at its end is loaded.
when a cassette at its end is loaded.
● During recording, sound is not heard from the speaker. To hear the sound,
connect optional headphones to the headphone connector. (GR-DVX709 only)
The sound volume is at the level it was adjusted to during playback. (
The sound volume is at the level it was adjusted to during playback. (
墌 pg. 22)
GR-DVX709SH_80-103.fm Page 81 Saturday, February 23, 2002 6:15 PM