JVC GR-DVX709SH Manuale Utente

Pagina di 104
82
 
EN
Master Page: Left-Heading0
GR-DVX709SH_80-103.fm
Page 82
TROUBLESHOOTING
If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.
Power
Video and D.S.C. (GR-DVX709/509 only) Recording
The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio, 
etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery 
pack, AC Adapter, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the 
beginning.
SYMPTOM
POSSIBLE CAUSES
CORRECTIVE ACTION
1. No power is supplied.
1. • The power is not connected 
properly.
• The battery is dead.
• The LCD monitor is not open 
fully or the viewfinder is not 
pulled out when recording.
1. • Connect the AC Adapter 
securely. (
墌 pg. 11)
• Replace the dead battery 
with a fully charged one. 
(
墌 pg. 10, 11)
• Open the LCD monitor fully 
or pull out the viewfinder.
SYMPTOM
POSSIBLE CAUSES
CORRECTIVE ACTION
2. Recording cannot be 
performed.
2. • The Power Switch is set to 
“P” or “OFF”.
— For Video Recording —
• The tape’s erase protection 
tab is set to “SAVE”.
• The VIDEO/MEMORY 
Switch is set to “MEMORY”.
• “TAPE END” appears.
• The cassette holder cover is 
open.
— For D.S.C. Recording —
• The VIDEO/MEMORY 
Switch is set to “VIDEO”.
2. • Set the Power Switch to “A” 
or “M”. (
墌 pg. 14)
— For Video Recording —
• Set the tape’s erase 
protection tab to “REC”. 
(
墌 pg. 16)
• Set the VIDEO/MEMORY 
Switch to “VIDEO”.
• Replace with new cassette. 
(
墌 pg. 16)
• Close the cassette holder 
cover.
— For D.S.C. Recording —
• Set the VIDEO/MEMORY 
Switch to “MEMORY”.
3. When shooting a subject 
illuminated by bright light, 
vertical lines appear.
3. • This is a result of exceedingly 
high contrast, and is not a 
malfunction.
3.
4. When the screen is under 
direct sunlight during shooting, 
the screen becomes red or 
black for an instant.
4. • This is not a malfunction.
4.
5. During recording, the date/ 
time does not appear.
5. • “DATE/TIME” is set to “OFF”. 5. • Set “DATE/TIME” to “ON”. 
(
墌 pg. 38, 49)
GR-DVX709SH_80-103.fm  Page 82  Saturday, February 23, 2002  6:15 PM