VistaQuest VQ350 Manuale Utente

 

3. Power-ON/Off the Camera   
Hold down the Power ON/OFF Button for 2 seconds to turn-on/off VQ350 immediately.     
 
 
4. Capturing Images   
Step 1: Turn On VQ350 by holding down 

          the Power Button for two seconds. 

Step 2: Press the Shutter Button to capture an image. 

 
 
5. Flash Charging 
Press Mode Button until “ So ” appears on the LCD display, then press the Shutter Button 
within 3 seconds to start charging the flash.    The lightening icon “      ” will blink continuously  
until it is fully charged.   
 
 
6. Self-Timer   
If you would like to include yourself in the image you wish to capture, you may use   
the self-timer feature to delay the camera by ten (10) seconds.    Place the camera on a 
tripod or a flat, stable surface.    Turn on the camera.    Press the Mode Button until   
the “        ” icon appears on the LCD display. Press the Shutter Button.    The camera will beep   
as it counts down and will capture an image automatically after 10 seconds. 
 
 
7. AVI Capture 
You can capture motion-video clips using the AVI Capture feature.    The image is stored in AVI 
format.    The image counter increments by one after movie clips are stored.    Video clips are 
captured at a resolution of 320 x 240.    The movie-clip frame rate will be approximately six 
frames per second.    Movie clips are silent.    (No audio.)    To use the AVI Capture mode follow 
these steps: