Toshiba IK-WB21A Manuale Utente

Pagina di 65
75
Viewing
Listening
and Operation
Others
Set up
Introduction
Recording
74
Viewing
Listening
and Operation
Others
Set up
Introduction
Recording
● Alarm In/Ext. Control In
1) Set an "alarm" to be detected.
Alarm In:
Detects an external alarm.
Ext. Control In: Performs external control.
OFF:
Does not perform "Alarm In" or "Ext. Control In."
2) Set "Input type" for alarms if "Function" is set to other than "OFF."
Normally Opened (NO): A no-voltage contact system.  Set in case of
normally open, closed in case of an alarm.
Normally Closed (NC): A no-voltage contact system.  Set in case of
normally closed, open in case of an alarm.
NOTE
Camera starts alarm recording when camera detects alarm signal. (Signal
lenghth requires more than 100ms).
Camera starts "Ext. Control In Recording" when control signal comes in.
(Control signal should be more than 1 second).
● Motion Detection
1) Function
ON: Camera detects motion.  (A change in the screen is detected and
an alarm is sent)
OFF: Camera does not detect motion.
2) Sensitivity
Set "Sensitivity."
HIGH:
It works with even a small change in brightness or motion is
detected.
MIDDLE: Intermediate between HIGH and LOW.
LOW:
It works only when a large change in brightness or motion is
detected.
NOTE
Detection sometimes fails if the object is dark.
Incorrect detection is sometimes made due to noise if the object is dark and
AGC gain is high.  Set the sensitivity to low.
● Output Hold Time
Set a time to hold alarm output.
Choose from 1, 5, 10, 15, 30 and 60 seconds
This function is used when connecting to alarm output terminals and
activating a siren, buzzer or emergency light.
Camera/Alarm Settings (Cont.)
Camera/E-mail Settings
E-mail can be sent to a maximum of 11 destinations including the administrator
e-mail address in case of Alarm In or Motion Detection.
1
Click "Camera Settings" on the Admin. Menu.
・ A sub menu for Camera Settings will appear.
2
Click "5. E-mail" in the sub menu.
・ The screen of "Camera - E-mail Settings" Settings will appear.
3
Configure each setting items.
・ Click the Save button to save settings.
・ The settings will not be reflected unless the Save button is clicked.