Fujitsu C150-E049-02EN Manuale Utente

EEPROM  WRITE?

(Mode 2 Write)

Screen 5

5 To set the status in EEPROM, press [Mode 1]

until * blinks. Then press [Mode 2] to change the

LCD display into Screen 5. If you want to set,
press [Mode 2]. And the LCD displays Screen 6
about three seconds.

6 If you want to return to the ENDORSER

INITIAL screen (Screen 2), press [Mode 1] and
[Mode 2] at a time.

7 If you want to return to the initial status to read,

press [STOP].

You can choose whether to reset or not when HOPPER EMPTY is detected.

8 At Screen 1 press [Mode 1] nine times to go to the

ENDORSER RESET METHOD screen.
(Screen 7)

9 Press [Mode 2] to see Screen 8. If “ON” is

displayed, the print number will be reset when
HOPPER EMPTY is detected. If “OFF” is
displayed, it wouldn’t. The “ON” or “OFF”
status flips each time you press [Mode 1]. The
status will be set in EEPROM automatically.

10 If you want to return to Screen 7 , press [Mode

2].

If you want to close the job, go to 7 .

You can reset the print number to the initial number by operator panel as
follows.

11 At Screen 1 press [Mode 1] ten times to go to

the ENDORSER RESET screen. (Screen 9)

EEPROM Writing!!

Screen 6

<< SETUP MODE >>

ENDORSER  RESET METHOD

Screen 7

HOP-EMPTY RESET

ON

Screen 8

<< SETUP MODE >>

ENDORSER  RESET

Screen 9