Teledyne T100 Manuale Utente
Communications Setup and Operation
Teledyne API - T100 UV Fluorescence SO2 Analyzer
144
Baud Rate: 115200
COM2 Mode Settings:
Quiet Mode
ON
SECURITY MODE
OFF
Computer Mode
ON
MULTIDROP MODE
OFF
MODBUS RTU
OFF
ENABLE MODEM
OFF
MODBUS ASCII
OFF
ERROR CHECKING
ON
E,8,1 MODE
OFF
XON/XOFF HANDSHAKE
OFF
E,7,1 MODE
OFF
HARDWARE HANDSHAKE OFF
RS-485 MODE
OFF
HARDWARE FIFO
ON
COMMAND PROMPT
OFF
6. Next, configure your communications software, such as APIcom. Use the COM port
determined in Step 4 and the baud rate set in Step 5. The figures below show how
these parameters would be configured in the Instrument Properties window in
APIcom when configuring a new instrument. See the APIcom manual (PN 07463)
for more details.
these parameters would be configured in the Instrument Properties window in
APIcom when configuring a new instrument. See the APIcom manual (PN 07463)
for more details.
Note
USB configuration requires that the baud rates of the instrument and
the PC match; check the PC baud rate and change if needed.
the PC match; check the PC baud rate and change if needed.
Using the USB port disallows use of the rear panel COM2 port except
for multidrop communication.
for multidrop communication.
06807C DCN6650