Empire Products FAW-55IP Manuale Utente

Pagina di 20
12429-10-0408
Page 10
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING:  If you do not follow these instructions exactly, a fire or explosion may result 
causing property damage, personal injury or loss of life.
A.   This appliance is equipped with an ignition device which 
automatically lights the pilot.  
Do not try to light the pilot by hand.
B.   BEFORE OPERATING  smell all around the appli-
ance area for gas.  Be sure to smell next to the floor 
because some gas is heavier than air and will settle on 
the floor.
 
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; 
  Do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s 
phone.  Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire 
department.
C.   Use only your hand to push in or turn the gas control 
knob.  Never use tools.  If the knob will not push in or 
turn by hand, don’t try to repair it; call  a  qualified 
service technician.  Force or attempted repair may 
result in a fire or explosion.
D.   Do not use this appliance if any part has been under 
water.  Immediately call a qualified service technician 
to inspect the appliance and to replace any part of 
the control system and any gas control which has 
been under water.
  1.  STOP!      Read  the  safety  information 
above.
  2.  Set the thermostat to lowest setting.
  3.  Turn off all electric power to the appliance.
  4.  This  appliance  is  equipped  with  an  ignition 
device which automatically lights the pilot.  Do not try 
to light the pilot by hand.
  5.  Remove control access panel (lower front panel).
  6.  Turn  gas  control  knob  clockwise 
  to 
“OFF.”
  7.  Wait  ten  (10)  minutes      to  clear  out  any  gas.  
Then smell for gas, including near the floor.  If you smell 
gas, STOP! Follow “B” in the safety information above.  
If you don’t smell gas, go to the next step.
  8.  Turn  gas  control  knob  counterclockwise 
 to “ON”.
  9.  Replace  control  access  panel    (lower  front 
panel). 
 10.  Turn on all electric power to the appliance.
 11.  Set thermostat to desired setting.
 12.  If the appliance will not operate, follow the instructions 
“TO TURN OFF GAS TO APPLIANCE” and  call your 
service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
OPERATING INSTRUCTIONS
  1.  Set the thermostat to lowest setting.
  2.  Turn  off  all  electric  power  to  the  appliance 
if service is to be performed .
  3.  Remove  control  access  panel  (lower  front 
panel).
  4.  Turn gas control knob clockwise  
 
to “OFF.” Do not force.
  5.  Replace  control    access  panel    (lower  front 
panel).
LIGHTING INSTRUCTIONS