Desa CGMFP Manuale Utente

Pagina di 36
www.desatech.com
119315-01A
18
OPTIONAL WALL SWITCH - GWMS2 
(Remote-Ready Models Only)
  WARNING:  Read  and  fol-
low  installation  instructions. 
Installation should be done by 
a qualified installer familiar with 
low-voltage wiring procedures.
 WARNING: Do not connect 
this  switch  to  any  electrical 
source! Electrical shock and/or 
fire hazard will occur.
1.  Connect  one  terminal  of  25  ft.  wire  to 
“TPTH” terminal on control valve (see Fig-
ure 23, page 17).
2.  Connect remaining wire terminal to the “TH” 
terminal on the control valve. Make sure that 
wire terminals are in the positions on your unit 
as pictured in Figure 23, page 17. If wires are 
not “crossed” the thermostat will not work.
3.  Route the 25 ft. wire to a convenient location 
to mount your wall switch (no outside walls).
 WARNING: Do not connect 
the  switch  to  a  power  source. 
Electrical shock and/or fire haz-
ard will occur.
IMPORTANT:
 The wire may be shortened but 
must not be lengthened.
4.  Connect one bare wire end to each of the 
terminals of the provided wall switch.
5.  Install the wall switch and cover in the wall.
INSTALLING LOG SET AND SCREEN
1.  Remove log packaging material and discard 
packaging. Gently place log over the burner (see 
Figure 26). Do not allow log to contact flame. If 
flame contacts log, soot will be created.
2.  Reattach screen by placing the notches in the 
screen frame over the shoulder screws and 
pushing down.
iNsTallaTioN
Continued
Log
Shoulder Screw
Screen
Figure 26 - Installing Log and Screen
opERaTiNG FiREplaCE
MaNUal-CoNTRollED 
MoDEls
FOR YOUR SAFETY 
READ BEFORE LIGHTING
 WARNING: If you do not fol-
low  these  instructions  exactly, 
a  fire  or  explosion  may  result 
causing property damage, per-
sonal injury or loss of life.
A.  This appliance has a pilot which must be 
lighted by hand. When lighting the pilot, 
follow these instructions exactly.
B.  BEFORE LIGHTING smell all around the 
appliance area for gas. Be sure to smell next 
to the floor because some gas is heavier than 
air and will settle on the floor.
  WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not 
use any phone in your building.
• Immediately call your gas supplier from 
a  neighbor’s  phone.  Follow  the  gas 
supplier’s instructions.
• If you cannot reach your gas supplier, call 
the fire department.
C.  Use only your hand to push in or turn the 
gas control knob. Never use tools. If the 
knob will not push in or turn by hand, don’t 
try to repair it, call a qualified service tech-
nician or gas supplier. Force or attempted 
repair may result in a fire or explosion.