Friedrich SL28N30 Manuale Utente

25

NOTE:  Hardware and accessories used during installation are shown 

on page 23.  Each part will be referred as Item No. 

Remove the chassis Entrygard retainer by removing the far 
right screw (See Figure 15), save this screw to reattach the 
chassis retainer after installation (Step 12).  Also, remove and 
discard the two retainer screws and washers located at the 
rear of the unit (See Figure 15).

Handle Use
Use handle on both sides to
pull unit from sleeve.

Do not push, pull or lift from
center of support.

FRR011

RETAINER SCREWS
AND WASHERS

FAR RIGHT

SCREW

ENTRYGARD
RETAINER
WIRE

FRR012

CONTROL UNIT

SUPPORT BRACKET

Hold the cabinet stationary, then use the hand grips on both 
ends of the control unit support bracket to pull the chassis out 
of the cabinet (See Figure 16). 

Remove the large white foam blocks used to restrain the 
compressor during shipment (See Figure 17).  Inspect base 
pan for dislodged white foam blocks and remove.  Do not 
remove any other foam parts.

Anchor the side angles (Item 6) by engaging the tabs of the 

lower sill plate (See Figure 18, Detail B-2) with the loops of the 
side angle.  Engage the tabs of the top angle (Item 5) with the 
top loops of the side angle (See Figure 18, Detail B-1).  Install 
two (2) screws (Item 7) to secure the top angle tabs and the 
side angle to the cabinet (See Figure 18, Detail B-1).

Use Handle

Locations

(both sides)