Friedrich SL28N30 Manuale Utente

26

Remove Shipping Blocks
Prior to operating the unit remove
the foam shipping blocks.

Failure to do so may result in
damage to the unit which is not
covered by the manufacturer’s
warranty!

FRR045

REMOVE AND DISCARD

FOAM BLOCKS

FAN MOTOR

EVAPORATOR COIL

COMPRESSOR

REMOVE AND SAVE
SCREW FOR
RE-INSTALLATION

REMOVE AND DISCARD
SCREWS

NOTE: 

DO NOT LEVEL the cabinet from front to back.  Make sure there 
is approximately 3/8” to 1/2” slope (1/8 to 1/4 bubble on level) 
toward the outside of the house.

Adjust the support brackets to provide an inside-to-outside slope for excess 
condensation drainage (Refer to Standard Window Installation, Figures 20 
through 24).  Tighten all screws.

Alternate support method A:  If you have a wide window sill which prevents 

rackets as shown in Figure 23, try the following:  

Using the elongated holes and different hole locations in the cabinet, 

bracket to support the unit’s weight (Figure 23).  

Tighten all screws.

Alternate support method B:  If the window ledge gap is narrow, try the 

as shown in Figure 24.  Bend the short piece so it will be vertical when 
installed.  Adjust the placement as required.  Tighten all screws.

he window side channels and cabinet. (Figure 25).  

Make sure you include the depth of the window channel.

Check the window sill and frame to be sure they are in good 

CABINET MOUNTING – Raise the lower window 1/4" more 
than the height of the cabinet.  Carefully slide the cabinet 
through the opening until the lower sill plate channel rests 
behind the window sill and the top angle rests against the 
window (See Figure 19).  Center the cabinet  within the 
opening.  Drill three (3) 5/32" diameter pilot holes into window 

sill using the holes in the cabinet sill plate as a guide.  Install 
three (3) #12 x 2" long screws (Item 4) (See Figure 19).

 OUTSIDE SUPPORT MOUNTING – Refer to Figures 20 and 
21.  Assemble the support brackets (Item 1) to the bottom of 
the cabinet with four (4) 10-24 1” long screws (Item 2) and four 

combination of the elongated holes of the bracket and different 
hole locations in the cabinet, to bring the bottom support bracket 
pads in contact with the wall.  A 1" x 4" or 2" x 4" SPACER 
SHOULD BE USED BETWEEN THE WALL AND SUPPORT 
THE BRACKETS WHEN INSTALLED ON ALUMINUM OR 
VINYL SIDING.  Drill 5/32" diameter pilot holes and secure 
the brackets to the wall with two (2) 12A x 2" long screws  
(Item 4).

For YOUR security and safety, YOU must
provide a means of preventing the upper
part of the window from opening.

t 

"

J

" 

e

h

t 

n

o

 

h

s

u

p

 ,

s

l

e

n

a

p

 

d

r

a

o

b

g

n

i

w

 

e

h

t 

e

l

b

m

e

s

s

a

 

o

T

 ype 

speed 

nuts (Item 9) and spring steel clips (Item 10) (See Figures 26) 
on page 31.  Secure each panel with two (2) screws (Item 11).

you from mounting the b 

set the placement of the

             between t