NEC PX602WL-BK Manuale Utente

2. Projecting an Image (Basic Operation)

Adjusting the Tilt Foot

1. The position to project image may be adjusted by the tilt feet

positioned at right, left and rear of the cabinet bottom.

The tilt foot height can be adjusted by its turn.
“To adjust the height of the projected image”
The height of the projected image is adjusted by turning the left and

right tilt feet.

“If the projected image is tilted”
If the projected image is tilted, turn one of the tilt feet to adjust the

image so that it is level.

“To adjust the projector so that it is perpendicular to the screen”
Turn the rear tilt foot to adjust its height.

• If the projected image is distorted, see “3-7 Correcting Horizontal

and Vertical Keystone Distortion [CORNERSTONE]” (

→ page

)

and “[GEOMETRIC CORRECTION]” (

→ page

100

• The tilt foot can be lengthened by a maximum of 48 mm.
• The tilt foot can be used to tilt the projector by a maximum of 6°.

NOTE:

• Do not lengthen the tilt foot any more than 50 mm/1.9". Doing so will make the

tilt feet’s mount section unstable and could cause the tilt feet to come off the

projector.

• Do not use the tilt foot for any purpose other than adjusting the projector’s

projection angle.

Handling the tilt foot improperly, such as carrying the projector by grasping the

tilt foot or hooking it onto a wall using the tilt foot, could damage the projector.

Tilt foot
(there is one more in the rear)

Down