3com 3CRUS2475 Manuale Utente

C

HAPTER

 1: U

SING

 

THE

 CLI

■

Ethernet — Contains commands to manage port configuration. The 
interface ethernet Global Configuration mode command is used to 
enter the Interface Configuration mode to configure an Ethernet type 
interface.

■

Port Channel — Contains commands to configure port-channels, for 
example, assigning ports to a port-channel. Most of these commands 
are the same as the commands in the Ethernet interface mode, and 
are used to manage the member ports as a single entity. The 
interface port-channel Global Configuration mode command is 
used to enter the Port Channel Interface Configuration mode.

■

SSH Public Key-chain — Contains commands to manually specify 
other device SSH public keys. The crypto key pubkey-chain ssh 
Global Configuration mode command is used to enter the SSH Public 
Key-chain Configuration mode.

■

QoS — Contains commands related to service definitions. The qos 
Global Configuration mode command is used to enter the QoS 
services configuration mode.

■

MAC Access-List — Configures conditions required to allow traffic 
based on MAC addresses. The mac access-list Global Configuration 
mode command is used to enter the MAC access-list configuration 
mode.

The device can be managed over a direct connection to the device 
console port or via a Telnet connection. The device is managed by 
entering command keywords and parameters at the prompt. Using the 
device command-line interface (CLI) is very similar to entering commands 
on a UNIX system.

If access is via a Telnet connection, ensure that the device has a defined IP 
address, corresponding management access is granted, and the 
workstation used to access the device is connected to the device prior to 
using CLI commands.

The following instructions are for use on the console line only.