Yamaha RX-A2010 Manuale Utente

En

“Completed” appears when the pairing is complete.

• Depending on Bluetooth components, “BT connected” appears when the 

pairing is complete. In this case, the wireless connection has been already 
established. You just need to start playback on your Bluetooth component to 
enjoy it on this unit.

When the pairing is complete, follow the procedure below to 
establish a wireless connection between your Bluetooth component 
and the Bluetooth receiver. When the connection is established, 
this unit outputs sounds played back on the Bluetooth component.

• Depending on Bluetooth components, a wireless connection is established 

automatically or by operating the Bluetooth component. In this case, you can skip 
steps 2 and 3 below.

• Texts in parentheses denote indications on the front display.

“BT connected” appears when the wireless connection is 
established.

• If the Bluetooth receiver is paired with more than one Bluetooth component, 

the lastly-connected component is automatically chosen. When you cannot 
establish a connection with an intended component, perform pairing again 
or perform the connection operation from the intended component.

• “Not found” appears if a connection cannot be established. Check the 

followings and try again.

- The Bluetooth component and Bluetooth receiver are paired.

- The Bluetooth component is turned on and the Bluetooth mode is enabled.

- The Bluetooth component is within 10 m (32 ft) of the Bluetooth receiver.

• To terminate the wireless connection, select “Disconnect” (Disconnect) in 

step 3.

C o m p l e t e d

D O C K

B T  c o n n e c t e d