ONKYO HT-R510 Manuale Utente

Pagina di 48
 
5
 
Before Using the HT-R510
 
Notes:
 
• The supplied batteries should last for about six months, 
although this will vary with usage.
• If the remote controller doesn’t work reliably, try replacing 
both batteries.
• Don’t mix new and old batteries, or different types of bat-
teries.
• If you intend not to use the remote controller for a long 
time, remove the batteries to prevent possible leakage and 
corrosion.
• Flat batteries should be removed as soon as possible to pre-
vent possible leakage and corrosion.
To use the remote controller, point it at the HT-R510’s 
remote control sensor, as shown below. The HT-R510’s 
STANDBY indicator flashes while a signal is being received 
from the remote controller.
 
Notes:
 
• The remote controller may not work reliably if the 
HT-R510 is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in mind 
when installing the HT-R510.
• If another remote controller of the same type is used in the 
same room, or the HT-R510 is installed close to equipment 
that uses infrared rays, the remote controller may not work 
reliably.
• Don’t put anything, such as a book, on the remote control-
ler, because the buttons may be pressed inadvertently, 
thereby draining the batteries.
• The remote controller may not work reliably if the 
HT-R510 is installed in a rack behind colored glass doors. 
Keep this in mind when installing the HT-R510.
• The remote controller will not work if there’s an obstacle 
between it and the HT-R510’s remote control sensor.
 
Installing the Batteries
 
1
 
Open the battery compartment, as shown.
 
2
 
Insert the two supplied batteries (AA/R6) in 
accordance with the polarity diagram inside 
the battery compartment.
 
3
 
Close the battery compartment.
 
Using the Remote Controller
30˚
30˚
HT-R510
Remote control sensor
Standby indicator
Appr
ox
. 16 ft.
 (5 m)