Lyngdorf Audio TDA 2200 Manuale Utente
37
14. Connectors
a. Mains Connector
Mains voltage to the TDA 2200 is applied via an IEC320 type connector. The supplied
cable with safety ground should be used to connect the TDA 2200 to a mains outlet.
WARNING: Connect the power input only to the AC source printed on the
label. The warranty will not cover any damage caused by connecting to the
wrong type of AC mains.
label. The warranty will not cover any damage caused by connecting to the
wrong type of AC mains.
WARNING: Always disconnect the TDA 2200 from the mains before
changing any connections to its inputs or outputs.
changing any connections to its inputs or outputs.
b. Loudspeaker Connectors
The TDA 2200´s loudspeaker connectors accept bare wire ends up to 5 mm in diameter.
Connect the wires from each loudspeaker to each channel's + and – terminals. Do not
make any other connections to the output terminals. Ensure the loudspeaker cable is
inserted into the slot in the loudspeaker terminal, and the terminal is tightened firmly.
WARNING: Always disconnect the TDA 2200 from the mains before
changing any connections to its inputs or outputs.
changing any connections to its inputs or outputs.
WARNING: Make sure that no conductive part of the loudspeaker wiring is
accessible. Do not connect loudspeakers with uninsulated terminals.
accessible. Do not connect loudspeakers with uninsulated terminals.
When the TDA 2200 is operating, there is up to 35V DC on its output terminals with
reference to ground.
reference to ground.
Do not connect the output from the amplifier to any other amplifier's output
or any other voltage source. Do not attempt to operate the amplifier in
bridged mono mode.
or any other voltage source. Do not attempt to operate the amplifier in
bridged mono mode.