Kenwood KDC-BT652U Manuale Utente
30
English
Installing the Microphone Unit (KDC-X696 only)
1
Check the installation position of the
microphone H.
microphone H.
2
Remove oil and other dirt from the
installation surface.
installation surface.
3
Install the microphone.
4
Wire the microphone cable up to the
hands-free box with it secured at several
positions using tape or the like.
hands-free box with it secured at several
positions using tape or the like.
■
■
Install the microphone as far away as
possible from the cell-phone.
possible from the cell-phone.
H
Fix a cable with a commercial
item of tape.
Peel off the release
coated paper of
double-face adhesive
tape to secure the
microphone on the
place shown above.
Turn the microphone
toward the driver.
Troubleshooting
Symptom
Remedy/Cause
Sound cannot be heard.
Adjust the volume to the optimum level. / Check the cords and connections.
“PROTECT” appears and no operations can
be done.
be done.
Check to be sure the terminals of the speaker leads are covered with insulating tape
properly, then reset the unit. If “PROTECT” does not disappear, consult your nearest
service center.
properly, then reset the unit. If “PROTECT” does not disappear, consult your nearest
service center.
The unit does not work at all.
Reset the unit.
Radio reception is poor. / Static noise while
listening to the radio.
listening to the radio.
Connect the antenna firmly. / Pull the antenna out all the way.
“IN” flashes.
The CD player is not operating properly. Reinsert the disc properly. If the condition did
not improve, turn off the unit and consult your nearest service center.
not improve, turn off the unit and consult your nearest service center.
CD-R/CD-RW cannot be played back and
tracks cannot be skipped.
tracks cannot be skipped.
Insert a finalized CD-R/CD-RW (finalize with the component which you used for
recording).
recording).
Disc sound is sometimes interrupted.
Stop playback while driving on rough roads. / Change the disc. / Check the cords and
connections.
connections.
“NA FILE” appears.
The unit is playing an unsupported audio file.
“NO DISC” appears.
Insert a playable disc into the loading slot.
“TOC ERROR” appears.
The CD is quite dirty. / The CD is upside-down. / The CD is scratched a lot. Try another
disc instead.
disc instead.
“ERROR 99” appears.
The unit is malfunctioning for some reason. Press the reset button on the unit. If the
“ERROR 99” code does not disappear, consult your nearest service center.
“ERROR 99” code does not disappear, consult your nearest service center.
B64-4919-00_02_K.indb 30
11/12/21 9:33