TOA Electronics VM-2120 Manuale Utente
58
24.5. Recorded Message-to-Group Assignment Operation
Here, the operation example of assigning Recorded Message 1 to Broadcast Groups 1, 3, and 4 will be
explained. (See p. 52 "Message 1 to group" setting example.)
explained. (See p. 52 "Message 1 to group" setting example.)
Step 1. Entry to recorded message setting mode
Press and release the Reset key while holding down the
ZONE 1 and ZONE 3 keys. When all indicators for
Zones 1 – 5 begins to flash (2 – 3 seconds after),
release both the ZONE 1 and ZONE 3 keys.
ZONE 1 and ZONE 3 keys. When all indicators for
Zones 1 – 5 begins to flash (2 – 3 seconds after),
release both the ZONE 1 and ZONE 3 keys.
The unit will be placed in recorded message setting
mode.
The 5 indicators for ZONE 1 through ZONE 5 begin to
flash. (They indicate Message 1 through Message 5.)
mode.
The 5 indicators for ZONE 1 through ZONE 5 begin to
flash. (They indicate Message 1 through Message 5.)
Operations of Steps 2 – 6 described hereafter are the same as those described in the previous section Control
input/Telephone paging/Westminster chime-to-Group assignment. However, read 5 setting items of Inputs 1 –
3, TEL paging, and Westminster chime as Messages 1 – 5.
input/Telephone paging/Westminster chime-to-Group assignment. However, read 5 setting items of Inputs 1 –
3, TEL paging, and Westminster chime as Messages 1 – 5.
Shown on the right is the status of each indicator that results
from the group number setting (Example. Groups 1, 3, and 4)
performed in Step 4.
from the group number setting (Example. Groups 1, 3, and 4)
performed in Step 4.
ZONE 1
ZONE 3
Reset
ZONE 1
ZONE 2
ZONE 3
ZONE 4
ZONE 5
ALL
Message 1
Message 5
ZONE 1
ZONE 2
ZONE 3
ZONE 4
ZONE 5
ALL
Group 1
(Message 1)
(Message 1)
Group 5