Petsafe RFA-200 Manuale Utente

18 

• Check battery to make sure it is installed properly. 
• Check that both lights are lit on the Fence Transmitter. If not, perform 

the “Short Loop Test”. 

• Make sure the Static Correction Level is set at 2 or above.
• Test the Receiver Collar with the Test Light.
• If the Test Light fl ashes, check the fi t of the Receiver Collar.
• Trim your pet’s fur where the Contact Points touch the neck and/or switch 

to the longer Contact Points. 

• Increase the Static Correction Level.
• Repeat training steps to reinforce training. 

• Replace battery. 
• Adjust Boundary Width Control knob clockwise to increase the distance 

from the Boundary Wire that the Receiver Collar activates. You can also 
adjust the Boundary Control Switch to another setting.

• If using a Double Loop, make sure Boundary Wires are separated 3 to 5 

feet.

• If the Receiver Collar still has to be held on top of the Boundary Wire, 

perform the “Short Loop Test.”

• Turn the Boundary Width Control knob counterclockwise to decrease the 

distance from the Boundary Wire that the Receiver Collar activates. 

• Make sure the Boundary Wire is not running too close to the house. The 

signal can transmit through the walls of your house. 

• Make sure Boundary Wires are twisted from Boundary to the Fence 

Transmitter.

• Make sure Fence Transmitter is at least 3 feet from large metal objects or 

appliances. 

• Make sure all Boundary Wire turns are gradual.
• Make sure the Boundary Wire is not running parallel to and within 5 feet 

of electrical wires, neighboring containment systems, telephone wires, 
television or antenna cables, or satellite dishes.

• If a neighboring containment system may be causing an inconsistent 

signal, contact the Customer Care Center at 1-800-732-2677 to see if a 
different frequency system will help your situation. 

• Check that the Power Adapter is plugged into the Fence Transmitter. 
• Try plugging into another 120-volt outlet. 
• If the lights still do not come on, the Fence Transmitter and/or Power 

Adapter needs to be replaced. Contact the Customer Care Center at 
1-800-732-2677.

• Make sure both ends of the Boundary Wire are plugged into Boundary 

Wire Terminals and that ½ inch of the insulation is stripped so that the 
copper wire is exposed. 

• Perform the “Short Loop Test” to determine if the Fence Transmitter needs 

to be replaced or if the Boundary Wire is broken. 

• If the Fence Transmitter is functioning properly, you have a break in your 

Boundary Wire. See the “Locating a Break in the Wire” section in this 
guide.