Zenoah BCZ5000DL/DW Manuale Utente
9
BCZ4500DL / BCZ4500DW / BCZ4500CL / BCZ5000DL / BCZ5000DW / BCZ5000CL
rotate as soon as the engine is started by putting
the throttle into the start position. When starting
the engine, place the product onto the ground in a
flat clear area and hold it firmly in place so as to
ensure that neither the cutting part nor the throttle
come into contact with any obstacle when the en-
gine starts.
the throttle into the start position. When starting
the engine, place the product onto the ground in a
flat clear area and hold it firmly in place so as to
ensure that neither the cutting part nor the throttle
come into contact with any obstacle when the en-
gine starts.
IMPORTANT
•
Avoid pulling the rope to its end or returning it by re-
leasing the knob. Such actions can cause starter fail-
ures.
leasing the knob. Such actions can cause starter fail-
ures.
7. Pull out the throttle to return the choke to the open
position.
NOTE
• These model’s choke returns to the open position au-
tomatically when the throttle is pulled out.
8. Allow the engine to warm up for a several minutes
before starting operation.
NOTE
1. When restarting the engine immediately after stop-
ping it, leave the choke open.
2. Overchoking can make the engine hard to start due
to excess fuel. When the engine failed to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.
STOPPING ENGINE
1. Release the throttle lever and run the engine for half
a minute.
2. Shift the ignition switch to the STOP position.
IMPORTANT
•
Except for an emergency, avoid stopping the engine
while pulling the throttle lever.
while pulling the throttle lever.
STARTING ENGINE
WARNING
• The cutting head will start rotating upon the en-
gine starts.
1. Feed fuel into the fuel tank and tighten the cap se-
curely.
2. Rest the unit on a flat, firm place. Keep the cutting
head off the ground and clear of surrounding objects,
as it will start rotating upon starting of the engine.
as it will start rotating upon starting of the engine.
3. Push the primer pump several times until overflown
fuel flows out in the clear tube.
4. Move the choke lever to the closed position.
5. Set the ignition switch to the “RUN” position.
Place the unit on a flat, firm place.
Keep the cutting head clear of everything around it.
Keep the cutting head clear of everything around it.
6. While holding the unit firmly, pull out the starter rope
quickly until engine fires.
WARNING
• The product is equipped with a centrifugal clutch
mechanism, so the cutting attachment begins to
8. Operation
(1) choke lever
(2) close
(3) open
(2) close
(3) open
(1)
(1)
(2)
(3)
(1)
(1)
(1) Ignition switch
(1)
(1)
(1) Ignition switch