Land Pride RCRM2510 Manuale Utente
12
Section 1: Assembly and Set-Up
RCR2596, RCR2510 and RCRM2510 Rotary Cutters 312-753M
5/09/08
Land Pride
Pull-Type Cutter
Hitch Assembly
1.
Assemble tongue (#1) to the deck using hitch pins
(#2), spacer tubes (#3) and linch pins (#4).
(#2), spacer tubes (#3) and linch pins (#4).
NOTE: Do not tighten hardware until assembly is
complete. Refer to “Torque Values Chart for
Common Bolt Sizes” on page 38.
complete. Refer to “Torque Values Chart for
Common Bolt Sizes” on page 38.
22302
2.
Attach level rod assemblies (#8) to tongue (#1) using
clevis pins (#5), flat washers (#6) and cotter pins
(#7). Make sure level rod adjusting nuts are threaded
the same distance on both rods. This will ensure a
level unit.
clevis pins (#5), flat washers (#6) and cotter pins
(#7). Make sure level rod adjusting nuts are threaded
the same distance on both rods. This will ensure a
level unit.
3.
Remove hydraulic hose holder (#9) from the hitch
and install to the cutter deck with 3/4” x 1 1/2” GR5
hex head cap screw (#12) and 3/4” hex locknut (#13)
as shown. Tighten mounting bracket hardware as
needed to secure hose holder in place.
and install to the cutter deck with 3/4” x 1 1/2” GR5
hex head cap screw (#12) and 3/4” hex locknut (#13)
as shown. Tighten mounting bracket hardware as
needed to secure hose holder in place.
4.
Route hydraulic hose through the hose holder loop.
5.
Remove parking jack (#10) from its storage position
on the deck and attach to the tongue (#1). Secure
with attached pin (#11). Adjust jack to desired height.
on the deck and attach to the tongue (#1). Secure
with attached pin (#11). Adjust jack to desired height.
RCR2596 Hitch Assembly
Figure 1-4
22290
RCR2510 Hitch Assembly
Figure 1-5