Land Pride RCBM6610 Manuale Utente
27
Section 2: Adjustments
11/11/12
RCB6610 & RCBM6610 Series 2 S/N 944730+ Rotary Cutters 330-584M
Wing Deck Leveling
Refer to Figure 2-2:
The wing section will need adjusting if its top is not level
with the center deck top when wing is unfolded.
with the center deck top when wing is unfolded.
1.
With tractor hydraulics, raise wings fully up, remove
transport lock pin (#7) from holes "B", and store in
holes “A”. Be sure to secure transport lock pin with
hairpin cotter (#6).
transport lock pin (#7) from holes "B", and store in
holes “A”. Be sure to secure transport lock pin with
hairpin cotter (#6).
2.
Lower wing to ground position and pull cutter straight
forward six to ten feet to allow outer wing wheel to
properly align itself.
forward six to ten feet to allow outer wing wheel to
properly align itself.
3.
With tractor hydraulics, fully extend rephasing
cylinders ensuring all cylinders are fully extended.
Then lower cutter to approximate cutting height.
cylinders ensuring all cylinders are fully extended.
Then lower cutter to approximate cutting height.
4.
Shut tractor down properly before dismounting. Refer
to “Tractor Shutdown Procedure” on page 14.
to “Tractor Shutdown Procedure” on page 14.
5.
Check wing top to see if it is level with top of center
deck. If outer edge of wing is higher or lower than the
center deck, then level wing as follows:
deck. If outer edge of wing is higher or lower than the
center deck, then level wing as follows:
a. If the outer wing edge is higher than the center
deck, loosen adjusting nut (#9) to lower the outer
wing edge until wing is level. Tighten adjusting
nut (#10) to the correct torque when level.
wing edge until wing is level. Tighten adjusting
nut (#10) to the correct torque when level.
b. If the outer wing edge is lower than the center
deck, loosen adjusting nut (#10) several turns and
tighten adjusting nut (#9) until wing is level.
Tighten adjusting nut (#10) to the correct torque
when level.
tighten adjusting nut (#9) until wing is level.
Tighten adjusting nut (#10) to the correct torque
when level.
Front Skid Position
Figure 2-3
Leveling Wing Deck
Figure 2-4
37616
Guard Removed for Clarity
30165
8
9
B
A
Center Deck Leveling
Figure 2-2
30233