Land Pride rcfm3696 Manuale Utente

Section 2: Assembly of Optional Equipment

12/15/15

RCF3696, RCFM3696, RCF3610, & RCFM3610 Rotary Cutters 326-600M

Rubber Safety Guards (Optional)

DANGER

Rotary Cutters have the ability to discharge objects at high
speeds; therefore, the use of front and rear double chain safety
guards is strongly recommended when cutting along highways
or in areas where people may be present.

WARNING

Not all objects will be stopped by safety guards. Therefore, use
extreme caution when cutting in areas where people may be
present. It is best to operate the cutter when no one is nearby.
Stop blade rotation if someone is within several hundred feet.

Front Rubber Guards

Refer to Figure 2-4:

Attach front Rubber Deflectors (#1) and reflector
bracket (#4) to the deck front with 1/2" -13 x 3 1/2"
long carriage bolts (#2) and hex whiz nuts (#3).

If Constant Velocity driveline is included, attach
bearing support to front rubber guards using
steps 1 & 2 on pa ge 25 for installation instructions.

Tighten hex whiz nuts (#3) to the correct torque.

NOTE: Do not tighten hardware until assemblies
are complete. Refer to “Torque Values Chart” on
page 56.

NOTE: The two carriage bolts “A” are not used if CV
driveline option is included. See “Constant Velocity
Driveline” on page 25.

Rear Rubber Guard

Refer to Figure 2-3:

Attach rear rubber guard (#4) and rear guard
strap (#1) to the deck rear with 1/2" -13 x 1 1/2" long
carriage bolts (#2), and hex whiz nuts (#3).

Tighten hex whiz nuts (#3) to the correct torque.

Rear Rubber Guard (RCF(M)3696 Shown)

Figure 2-3

33956

Front Rubber Guard (RCF(M)3696 Shown)

Figure 2-4

33955